Morbo Hardware Kit - ONLY NEEDED IF PRINTING YOUR OWN MORBO

**KITS SHIP LATE OCTOBER. AWAITING STOCK OF RAK POWER CABLES!**

These two hardware kits includes the components needed if you print your own Morbo but do not contain the main electronics, antenna or batteries.

The kits include the following:

Standard Kit

• 1x M3 10mm Socket Cap Stainless Steel Head Screw
• 3x M3 18mm Socket Cap Stainless Steel Head Screws
• 7x M3 Flat Square Stainless Steel Nuts
• 2x M2.5 x 8mm Pozi Pan Head Screws
• 1x RAK 1W power cable with pre-soldered Power Switch
• 1x 20cm N-Type OR SMA to IPEX pigtail
• 4x 10cm cable ties
• 2x 43cm cable ties

Pro Kit - All of the above PLUS

• INA219 current/voltage sensor with screw headers (requires soldering)
• 1x 4 pin screw header for RAK (requires soldering)
• Pre-cut silicone wiring at required lengths for INA219